Caesar feed conveyor belt is a common problem moving conveyor belt, the reasons are multi-faceted. But the focus is to strengthen the daily care and maintenance. Sprinkle material reproduced point reprinted point spread mainly in the fall material hopper, guide trough places. The belt conveyor serious overload, conveyor belt guide trough gauge damage rubber apron, guide trough at the plate design is far longer rubber apron guide trough out of the material from the belt. The above can control the transport capacity, strengthen the maintenance to be resolved on maintenance. Install the belt conveyor is generally carried out according to the following stages. Installation rack mounting belt conveyor frame starting from scratch food conveyor belt, and then install the various sections in turn the intermediate frame, and finally the installation of the tailstock. Before installing a rack, first pulling the center line throughout the length of the conveyor belt conveyor, because keeping the center line of the conveyor in a straight line is an important condition for the normal operation of the conveyor belt, so in each section rack mount When a large belt conveyor, must be aligned with the center line, but also to put on airs leveling chassis centerline tolerance per meter captain of ± 0.1mm. However, the entire length of the conveyor frame center of error should not exceed 35mm. When all single install and identify after each block can be connected. Moving conveyor belt _ Oswald Chen Machinery (certified) _ Jiaozuo conveyor belt by Oswald Xinxiang Chen Machinery Co., Ltd. Oswald Xinxiang Chen Machinery Co., Ltd. (www.oweicjx.com) is an industry leader in Henan Xinxiang, transportation equipment, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In Oswald Chen mechanical leadership with the staff warmly welcome all inquiries negotiations to create Oswald Chen Machinery better future.